Trench Tank: S-ISU

My fellow crusaders of the Holy (and unholy) Trenches! Do you get tired of holding your own weapon or it just doesn't have enough caliber? Do you need a safe haven in the middle of warzone? Do you want to bring fear into your enemies hearts, while you blast their fortifications into thousand pieces? Look no further. Here is the first ever Trench Tank to solve your problems! This kit includes Trench Tank: S-ISU! Model is based on the ISU-152 design, but my hellish factory produced something of my own. I also included plenty of bits you can use to customize the tank as you want. AND as an extra, you get all the parts to create either very trenchified tank, or just a vanilla version, or anything in between!Scale: 32mmSize: Approx. 14x8x6cm (length, width, height - height is without the pyre)Size definition: A human trench miniature is standing about neck height to the mud guardCan be printed with: FDM or RESIN Included:- Trench Tank S-ISU (normal parts, closer to historical)- Trench Tank S-ISU (trench parts)- Check the pictures to see all the parts!- 6x different religious icon-plates- 2x wooden side armour plates- 1x metallic side armour plates- Tank chassis- Tank chassis with a pyre- Mud guards- Cannon- Cannon with attached corpses- BarrelsIncluded: Supported (+ hollowed) / non-supported and .Chitubox files of each partModel was test printed succesfully on FDM.Update v2:- Added carved versions of the barrels on top of the mud guards. Now you don't need to cut a piece off from the mudguard to be able to fit the barrels like in the render picture. Update v3 (Work done by a Diceverse subscriber / I checked the quality - thank you Anti!):-Added a cut version of Maria_Jeshua Icon panel-Standarised/equalized the sizes of icon panels-Two uncut panels are a bit larger - all complete/uncut panels have the same size Instructions for FDM printing:- The only parts that I suggest using supports are the ones with dead-bodies (Cannon pipe and files with the pyre) - otherwise everything should be printable without supports- If you get adhesion problems, I recommend using a raft.- Beginning of the printing process on some parts might look weird (looking at you tank-tracks) but just trust the process. This is the first part of my Tribes/Patreon February release. Want monthly Trench STLs? Consider joining my Tribes or Patreon! Limited amount of discounted Early Bird spots available: Tribes /// Patreon CHECK THE REST OF MY TRENCH STLS HERE